You have no items in your cart.

More Views

Close X

GPL 100 Ground Penetrating Locator Metal Detector

Sku: 315-818
Retail: $5,995.00
Now Only: $3,695.00
A Resistance Indicating Instrument. Scans up to 22,000 sq. ft. Operates Exactly the Same as the GPL 200

Availability: In stock

We accept Wire/Bank transfers - call 888-535-5926

GPL 100 Ground Penetrating Locator Metal Detector
A Resistance Indicating Instrument. Scans up to 22,000 sq. ft. Operates Exactly the Same as the GPL 200

Operates exactly the same as the GPL 200, with large Primary Carrier Wave Meter, Rods, Wire Spools, Battery Systems, etc. Capable of reading as far down as 50 ft. Excellent choice for serious treasure hunting at a low, affordable "budget" price.

Factory Included Accessories:
  • Analog Meter
  • 12V Gel Battery
  • Battery Charger
  • Battery Connectors
  • Four Standard Rods
  • Four 74 ft. Wire Spools

Additional Information

Not currently available.

GPL 100 Ground Penetrating Locator Metal Detector

Locate Treasures up to 100 Feet Deep!

Since we cannot see into the ground, and standard detectors using Transmit / Receive search coils are limited in depth and restricted to a "scan" area no larger than the search coil, it has been difficult for the serious treasure hunter to search large areas with any degree of accuracy, especially if searching at depths greater than one or two feet! But now, based upon "measurable resistively" detection sensors, it is possible to search large areas in less time, and to look for treasures as deep as 100 feet. All buried metals, precious and non-precious, oxidize and / or decay at different rates due to their particular metallic composition. Relative to the length of time metal objects are lost or secreted in the ground, they can be found with specialized equipment that measures the average or normal ground in an area, then by sending carrier wave signals through the ground, the GPL can locate the buried object or objects between the sensor probes.

The carrier wave ohm meter, found on both the GPL 100 & 200, is highly sensitive and can indicate a fairly precise signal of the target such as gold, silver, copper, iron) and even alert the user to tunnels and cave openings. The secondary meter(10XHigh/0.1X Low range meter) found only on the GPL 200, picks up signals ranging (both) higher and lower than the larger digital meter. The secondary meter measures resistively outside the normal range, enabling the user to continue to pick up signals when the normal meter would go "off the scale" and be lost. The GPL is a highly scientific and reliable treasure seeking sensor that is extremely easy to use. Merely insert the rods into the ground in a pattern indicated in the instructions. Press corresponding buttons. Measure resistively readings. Continue until sensor indicates a target, then dig and recover your treasure.

4 Easy Steps for Use
Click Here To Enlarge Picture
GPL

The Ground Penetrating Locator measures ground resistance from point to point, if the GPL indicates a high resistively it generally means you have found a cave or hidden tunnel. However, if the instrument shows a low resistance on the meter and the TARGET RESPONSE LAMP is lit, you can be sure that a metal target has been located. The TARGET RESPONSE LAMP indicates that a good conductor is absorbing the power due to a strong battery charge on the metal. The GPL has a special circuit that activates the lamp at varying degrees of brightness- the better the conductor, the brighter the lamp. The GPL has a variable power consumption circuit and uses very little power when the ground is inert or poor in conductivity. It has a maximum power of five amps, more than enough to allow the strongest conductor of precious metals to show its presence. When a strong, low frequency signal is transmitted through the ground from one ground probe (or rod) to another, the wave is used as a "radio carrier". The DC wave generated by a 12 volt battery is capable of traveling only a few inches through the ground. Changing the DC wave to an AC wave (also called a carrier wave) allows it to travel much further at low frequency. The wave will take the path of least resistance to travel through the ground. The CW easily travels through precious metals. If metal is in the wave's trajectory, the wave encounters resistance along its path. In this case, a "stronger" CW hits the receiving probe. This is how the TARGET RESPONSE LAMP on the GPL lights when a highly conductive (and therefore less resistant) target is located. All precious metals suffer a slight deterioration due to acid rain, snow, and other chemicals. When acid and ultra-high radiation contact metals, free electron radiation fields (FERFs) are created. The longer the object is buried, the stronger the field. Carrier waves are attracted to FERFs. As the CW sinks into the ground it has to disperse. By creating a strong charge that sinks into the ground, the CW will find the FERF, tune automatically to it and follow it. Those of us who look for precious metal have tried many methods over the years but none have been perfected to the level of the GPL.

 

Customer Reviews

This product has no reviews. and be the first to write one!

Garrett Metal Detectors
Minelab Metal Detectors
White's Metal Detectors
Nokta Metal Detectors
Makro Metal Detectors
Teknetics Metal Detectors
Fisher Metal Detectors
Tesoro Metal Detectors
MP Series Metal Detectors
Treasure Commander Metal Detectors
Cobra Metal Detectors
Aqua Scan Metal Detectors
Bounty Hunter Metal Detectors
See All Metal Detectors